MCD Racing RR5 Competition - Dr Ve-Tra N Ma Ntenance

12
1. Drll holes on the corners and center before cuttng out.
2. Cut the specfed lnes wth PC scssors.
3. Scratch the edges wth the cutter tool shown n Figure P.
4. Bend and brake the peces towards nsde of the body.
(We recommend to use mechanc gloves durng these steps)
Carburator access & Ar ntake
Pull start & Engne-o access
Power swtch access & Ar ntake
Body cut-out
Cut-out tips
Important!
Figure P
We recommend to ream out more
holes for coolng f the weather
temprature gets too hgh.
Drive-train maintenance
Apply grease nsde the boots and check frequently.
Replace them f they are rpped.
Apply chan lube nsde the CCD Axles
after every 3-4 tanks.
Important!
Important!