1
130826
INTRODUCTION
The Models C832 and C834 have two
independent upper platens. These grills
provide automatic leveling of the platens.
The grills are capable of cooking a variety of
products and feature two cooking options,
AUTO and MANUAL.
AUTO Option: The grills automatically detect
the product placed on the grill plate (menu
items that are cooked using the upper platen,
only) and set the appropriate cooking
parameters.
MANUAL Option: After the operator selects
the desired product to be cooked, the grills
automatically set the appropriate cooking
parameters.
These grills provide all the features of a flat
grill, as well as the advantages of two-sided
cooking.
All repairs must be performed by an
authorized Taylor service agent. The main
power supplies to the grill must be
disconnected prior to performing any repairs.
These grills are designed for indoor use
only.
Note: Only instructions originating from the
factory or its authorized translation
representative(s) are considered to be the
original set of instructions.
SAFETY
Always follow these safety precautions when
operating the grill:
DO NOT operate the grill without
reading this operator's manual. Failure to
comply may result in equipment damage or
personal injury. This manual should be kept in
a safe place for future reference.
This appliance is to be used only by
trained personnel. It is not intended for use by
children or people with reduced physical,
sensory, or mental capabilities, or lack of
experience and knowledge, unless given
supervision or instruction concerning the use
of the appliance by a person responsible for
their safety. Children should be supervised to
ensure that they do not play with the
appliance.
DO NOT install the unit in an area
where a water jet could be used. DO NOT use
a water jet to clean or rinse the grill. Failure to
follow this instruction may result in serious
electrical shock. In addition, water may collect
inside the grill and destroy electrical
components and cause injury from hot steam.
DO NOT operate the grill unless it is
properly grounded. Failure to comply may
result in equipment damage or personal injury.
This unit is provided with an equipotential
grounding lug that is to be properly attached to
the rear of the frame by the authorized
installer. The installation location is marked by
the equipotential bonding symbol (5021 of IEC
604171) on both the removable panel and the
equipment's frame.
S DO NOT operate the unit unless it is
properly grounded.
S DO NOT operate the unit with larger
fuses than specified on the data label.
S All repairs must be performed by an
authorized Taylor service technician.
S The main power supplies to the
machine must be disconnected prior to
performing any repairs.
S For Cord Connected Units: Only Taylor
authorized service technicians or
licensed electricians may install a plug
or replacement cord on these units.
To Next Page
Loading...
