McDonald's C832 - Non-Scheduled Maintenance; System Set-Up

54
101019
NON-SCHEDULED MAINTENANCE
WARNING: INSPECTION, TESTING,
AND REPAIR OF ELECTRICAL EQUIPMENT
SHOULD ONLY BE PERFORMED BY
QUALIFIED SERVICE PERSONNEL.
ALL ELECTRICAL CONNECTIONS
SHOULD BE DISCONNECTED AND THE
HOOD CIRCUIT BREAKER SHOULD BE
TURNED OFF WHEN SERVICING THE GRILL.
FAILURE TO DO SO MAY RESULT IN
EQUIPMENT DAMAGE OR PERSONAL
INJURY.
SYSTEM SET-UP
To enter the SYSTEM SET-UP menu, perform
the following steps.
1. While in the AM/PM AUTO Mode, press
the
key. The following screen will
display.
PRESS ENTER FOR
PROGRAMMING
2. Press the key to display the
passcode entry screen.
3. Enter the Manager Menu passcode by
pressing the keys in this order:
4. After the passcode has been entered,
press the
key until the screen
displays “SYSTEM SETUP.”
The following screen will display.
PRESS ENTER FOR
SYSTEM SETUP
5. Press the key to accept the
selection.
6. Press the
key until the desired
display screen appears.
Probe Calibration
1. Upon entering the SYSTEM SET UP
menu, the following screen will display.
PROBE CALIBRATION
TOP BACK +00 424
Note: The Probe Calibration screen can
also be accessed directly from the Main
Menu without entering a passcode by
pressing and holding the TEMP key for
three seconds.
2. Place a pyrometer surface probe in the
center of the selected heat zone.
3. If the displayed temperature on the
controller is more than 5°F/3°C different
from the pyrometer surface probe display:
Press the
key to increase the
temperature to match the displayed
temperatures.
Press the
key to decrease the
temperature to match the displayed
temperatures.