What to do if McHale 991 LBER Farm Equipment table rotates but bale not indexing?
If the table rotates but the bale isn't indexing, it could be that the table drive roller shearbolt is broken, in which case, replace the shearbolt. Alternatively, the gearbox cross shaft roll pins might be broken, so replace the roll pins.
How to fix McHale 991 LBER Farm Equipment table moving in tip position?
If the table is moving in the tip position, the drive chain may be loose. Tighten the chain to resolve this issue.
What to do if McHale Farm Equipment table stops in the wrong position (Electronic machines)?
If the table is stopping in the wrong position, especially on electronic machines, several factors could be at play. First, reset the magnets. Ensure the machine starts with the cut & hold at the rear. Adjust the slow down setting in the control box. Check the electrical connections related to the slow speed valve. Clean the slow speed cartridge. Finally, set the table rotation to 10 RPM, as the slow speed may be set too fast.
Why is McHale 991 LBER table slow to tip down?
If the table is slow to tip down, it could be due to back pressure being too high. Ensure a free flow return is fitted. Alternatively, the quick release couplings may be faulty; if so, replace them.
General| Brand | McHale |
|---|---|
| Model | 991 LBER |
| Category | Farm Equipment |
| Language | English |
Warns about entanglement risks with moving machine parts.
Covers critical safety aspects including safety devices and the 'Danger Zone'.
Details critical safety procedures for the hydraulic system.
Guides on configuring hydraulic spool valves based on tractor system type.
Step-by-step instructions for correctly attaching the wrapper.
Instructions for connecting the electronic control box and power supply.
Overview of the Bale Wrap Computer interface, buttons, and basic functions.
Details the function of each button on the Electronic Control Box.
Guide to navigating and configuring menus on the Electronic Control Box.
Crucial step to select the correct program for the machine's operation.
Steps to load film, connect computer, and set modes for wrapping.
Essential checks and safety procedures before operating on public roads.
Procedure for replacing the shearbolt on the table drive roller sprocket.
Procedure for replacing shear pins in the gearbox cross shaft.
Instructions on increasing and decreasing hydraulic accumulator pressure.
To Next Page
