11
How to Operate the C15 cont
Figure 5
Headphones Jack
Connect a pair of dynamic headphones to the Headphones
jack for private listening. Press Mute to mute all other out-
puts including the amplifier connected to the loudspeakers.
Refer to Figure 4
Reset of Microprocessors
In the event that the controls of the C15 stop functioning
push the POWER switch OFF and wait about two minutes,
then push the POWER switch ON followed by pushing the
STANDBY/ON push button. This will reset the C15 micro-
processors and the Preamplifier should be functioning nor-
mally.
NOTE: The above condition is usually caused by either
interruptions in AC power and/or major changes that
may occur in AC power line voltage.
Using a Signal Processor
When a signal processor is con-
nected, set the rear panel PRO-
CESSOR switch to the IN posi-
tion. Refer to Figure 5.
NOTE: When a signal processor
is connected and the C15
PROCESSOR Switch is set
to the IN position,, the
processor must be on, or
in bypass mode, for a
signal to pass through the
preamplifier.
How To Make A Tape Recording
1. Select the source signal you wish to record with the
appropriate front panel input push-button. If you wish
to record from an Audio/Video source connected to the
optional MVS-3 Audio/Video Selector, using the
HR033 Remote, first select Video and then the desired
source connected to the MVS-3. Refer to Figure 6.
2. Adjust the record level using the tape recorder volume
control and proceed with the recording process.
3. To listen to the tape playback of the program source
just recorded, press the TAPE input push-button. Refer
to Figure 6.
NOTE: The C15 TAPE OUTPUTS are not affected by the
VOLUME or BALANCE controls.
Figure 6
To Next Page
Loading...
Need help?
General