McIntosh C8AC User Manual

11
If the Loudspeaker’s impedance is in-between the
available connections, use the nearest lower imped-
ance connection. Refer to “General Information”
Note 3 on page 6 for additional information.
WARNING: Loudspeaker terminals are hazard-
ous live and present a risk of electric
shock. For additional instruction on
making Loudspeaker Connections con-
tact your McIntosh Dealer or McIn-
tosh Technical Support.
9. Connect the MC275 Power Cord to an active AC
outlet.
(ohms) connection to match the impedance of the
Loudspeaker, being careful to observe the correct
polarities.
If the Loudspeaker’s impedance is in-between the
available connections, use the nearest lower imped-
ance connection. Refer to “General Information” Note
3 on page 6 for additional information.
WARNING: Loudspeaker Terminals are hazardous
live and present a risk of electric shock.
For additional instruction on making
Loudspeaker Connections contact your
McIntosh Dealer or McIntosh Techni-
cal Support.
7. Connect the MC275 Power Cord to an active AC
outlet.
Spade Lug or Wire Connections:
8. Connect the Loudspeaker hookup cables to the
MC275 Negative Output Terminal (-) and Posi-
tive Output (+) Terminal indentified as 4Ω (ohms),
8Ω (ohms) or 16Ω (ohms) connection to match
the impedance of the Loudspeaker, being careful
to observe the correct polarities. Insert the spade
lug connector or prepared section of the cable end
into the terminal side access hole, and tighten the
terminal cap until the cable is firmly clamped into
the terminals so the lugs or wire cannot slip out. Do
not over tighten. Refer to gures 4, 5 and figure E.
Note: Refer to “Output Terminals” step 4 on
page 10 for important information.
How to Connect for Stereo Operation
Figure 4
Figure 5

McIntosh C8AC Specifications

General

Brand	McIntosh
Model	C8AC
Category	Amplifier
Language	English