MC 250
ELECTRICAL SPECIFICATIONS
Power Output:
100 watts RMS continuous, 50 watts per channel operating
simultaneously, into 4 ohm, 8 ohm, or 16 ohm loads.
Harmonic Distortion:
Less than 0.25% at rated power output from 20Hz to 20,000Hz.
Intermodulation Distortion:
Less than 0.25% for any combination of frequencies between
20 Hz and 20,000 Hz.
Frequency Range:
At rated output both channels: +0 to -0.25dB from 20Hz
through 20,000Hz.
Output Damping Factor:
Greater than 10 for any output tap.
Input Sensitivity & Impedance:
Input sensitivity is 0.5 volts. Input impedance Is 200K ohms.
Hum & Noise :
Greater than 90dB below rated output.
Power Requirements:
117 volts AC,50-60Hz, 50 watts at zero signal output, 250
watts at rated output.
To Next Page
Loading...
