Need help?Do you have a question about the McIntosh MC 250 and is the answer not in the manual?
General| Type | Solid State |
|---|---|
| Power Output | 50 Watts per channel |
| Input Sensitivity | 0.5V |
| Signal to Noise Ratio | 90 dB |
| Damping Factor | 20 |
| Input Impedance | 250k ohms |
| Frequency Response | 20 Hz - 20 kHz |
| Output Impedance | 4, 8 Ohms |
| Weight | 35 lbs |
Specifies the RMS continuous power output for the amplifier across different load impedances.
Details the maximum acceptable harmonic distortion levels from 20Hz to 20,000Hz.
Defines the maximum intermodulation distortion for frequencies between 20 Hz and 20,000 Hz.
Indicates the amplifier's frequency response at rated output for both channels.
States the minimum damping factor for any output tap, indicating amplifier control over speakers.
Provides the required input voltage for rated output and the input impedance.
Specifies the signal-to-noise ratio, indicating the level of unwanted noise.
Lists the voltage, frequency, and power consumption at zero and rated signal output.
Lists capacitor part numbers, descriptions, and their corresponding McIntosh part numbers.
Lists diode types, descriptions, and their corresponding McIntosh part numbers.
Details the fuse type and its McIntosh part number for replacement.
Lists transistor types, descriptions, and their corresponding McIntosh part numbers.
Lists potentiometer types, their function, and their corresponding McIntosh part numbers.
Lists resistor types, values, wattage, and their corresponding McIntosh part numbers.
Lists switch types, their function, and their corresponding McIntosh part numbers.
Lists transformer types and their corresponding McIntosh part numbers.
Lists other items like feet, manuals, knobs, and cords with part numbers.
To Next Page
