Need help?Do you have a question about the McIntosh MC352 and is the answer not in the manual?
General| Power Output | 350 watts per channel |
|---|---|
| Number of Channels | 2 |
| Total Harmonic Distortion | 0.005% |
| Frequency Response +0, -3dB | 10Hz to 100kHz |
| Signal to Noise Ratio | 112dB |
| S/N Ratio | 112dB |
| Dynamic Headroom | 1.8dB |
| Input Impedance | 10k ohms |
| Voltage Gain | 29dB |
| Dimensions | 9.5" (24.13cm) H x 17.5" (44.45cm) W x 18" (45.72cm) D |
| Weight | 98 lbs (44.45 kg) |
| Frequency Response | 20Hz to 20kHz +0, -0.25dB |
| Damping Factor | 40 |
| Output Impedance | 2, 4, or 8 ohms |
Details on the amplifier's power output capabilities and channels.
Explanation of the balanced input and output circuitry for reduced distortion.
Information on the circuit that prevents amplifier clipping and speaker damage.
Details on protection circuits for longevity and overheating.
Explanation of autoformers for impedance matching and DC protection.
Description of the peak-responding power output meters.
For audio cables from a preamplifier or control center.
For audio cables from a preamplifier or control center.
Receives turn on/off signals and sends them to next component.
Selects different modes of operation for inputs.
Selects different operation modes for outputs.
Connections for 2 ohm and 4 or 8 ohm loudspeakers.
Steps for preparing speaker cable ends for connection.
Guidelines for connecting speaker cables to terminals.
Connecting balanced outputs from a control center.
Indicates the Left/Right Channel Power Output of the amplifier.
Light up when the amplifier channel Power Guard circuit activates.
Selects the display modes of the power output meters.
Turns AC power on/off, or on/remote.
Instructions for powering the unit on manually or remotely.
How to select meter operation modes (Lights Off, Watts, Hold).
Explains stereo and mono operation configurations.
Allows selection of Balanced or Unbalanced inputs.
Steps for operating in Mono Mode as a 700 watt amplifier.
350 watts continuous average power output per channel.
700 watts continuous average power output.
Supported impedance for Stereo and Mono modes.
Frequency range for rated power output.
Measurement of headroom above rated power.
Details on the frequency response across different ranges.
Maximum THD across power levels and frequencies.
Maximum IM distortion for peak outputs.
SNR values for unbalanced and balanced inputs.
Input voltage requirements for unbalanced and balanced inputs.
Impedance values for unbalanced and balanced inputs.
Measure of amplifier's ability to control speaker motion.
Voltage and frequency requirements for operation.
Physical dimensions of the front panel and depth.
Net and shipping weight of the unit.
Detailed steps for properly packing the equipment for shipment.
List of parts and quantities for shipping the unit.
To Next Page
