Need help?Do you have a question about the McIntosh MC2301 and is the answer not in the manual?
General| Damping factor | 15 |
|---|---|
| Amplifier class | - |
| Frequency range | 10 - 100000 Hz |
| Output impedance | 8 Ω |
| Audio output channels | 1.0 channels |
| Peak power per channel | 300 W |
| Signal-to-Noise Ratio (SNR) | 117 dB |
| Total Harmonic Distortion (THD) | 0.5 % |
| Speakers connectivity type | Binding post |
| Purpose | Home |
| Product color | Black |
| Connectivity technology | Wired |
| AC input voltage | 120 V |
| AC input frequency | 50 - 60 Hz |
| LED indicators | Yes |
Weight and Dimensions| Depth | 584.2 mm |
|---|---|
| Width | 450.9 mm |
| Height | 312.7 mm |
| Weight | 52600 g |
Warning to reduce risk of fire or electrical shock by not exposing to rain or moisture.
Warning against opening the enclosure; refer servicing to qualified personnel.
Caution to remove foam inserts from vacuum tubes before connecting power to prevent fire hazard.
Contact details for technical help and customer service for product inquiries and repairs.
Specifies the amplifier's weight and the need for multiple persons to handle it safely.
Provides minimum spacing and ventilation cutouts for custom cabinet installations.
Describes the switch for selecting between balanced or unbalanced audio input modes.
Details speaker output connections for 2, 4, and 8 ohm loads, with polarity warnings.
Instructions on preparing speaker cable ends, including bare wire, spade lugs, and banana plugs.
Guidance on connecting a single loudspeaker to the correct impedance terminals, observing polarity.
Explains the function and modes of the illuminated power output meter.
Describes the function of the power switch for AC On/Off or Remote operation.
How to turn the amplifier on manually or via a remote control system.
Explains the Sentry Monitor protection circuit and the standby indicator light.
Lists power output ratings for different impedance loads and acceptable load impedances.
Details the frequency range and harmonic distortion levels of the amplifier.
To Next Page
