Need help?Do you have a question about the McIntosh MC462 and is the answer not in the manual?
General| Power Output per Channel | 450 Watts |
|---|---|
| Number of Channels | 2 |
| Total Harmonic Distortion | 0.005% |
| Frequency Response | 20Hz - 20kHz (+0, -0.25dB) |
| Dynamic Headroom | 1.8dB |
| Damping Factor | >40 |
| Rated Power Band | 20Hz - 20kHz |
| Frequency Response Extended | 10Hz - 100kHz (+0, -3dB) |
| Remote Power Control | Yes |
| Multi-Channel DB25 Cable | No |
| Output Impedance | 2, 4, 8 Ohms |
| Dimensions | 17.5 x 10.5 x 22 inches (W x H x D) |
Contact information for technical help and details on repair procedures.
Details on XLR, Power Control, and Output terminal connector types and configurations.
Explains power output, Quad Balanced Circuitry, and patented Autoformer technology.
Details on Power Guard, Sentry Monitor protection, and illuminated power meters.
Information on the special power supply and custom binding posts.
Explains the various input and output terminals on the rear panel.
Describes the power control jacks and input mode switches.
Step-by-step guide for connecting loudspeaker cables.
Recommendations for speaker wire gauge and cable preparation.
Procedure for connecting the amplifier for bi-amplification.
Details on the function of power output meters and indicator lights.
Describes the power switch operation and meter mode selection.
Instructions for powering on the unit and selecting meter modes.
Explanation of input mode selection and auto off power saving.
Covers design philosophy, Quad Balanced circuitry, Autoformer, and transistors.
Details on Sentry Monitor, Power Guard, and power output metering.
Explains Autoformer technology and its role in heat dissipation.
Details on the high current high voltage power supply circuits.
Specifications for power output, distortion, frequency response, and SNR.
Details on impedance, gain, sensitivity, dimensions, weight, and power requirements.
To Next Page
