McIntosh MT10

19
Packing Instructions
Packing Instructions
In the event it is necessary to repack the equipment
for shipment, the equipment must be packed exactly
as shown below. It is very important the four feet are
still attached to the bottom of the equipment. This will
ensure the proper equipment location on the bottom
pad. Failure to do this will result in shipping damage.
Use the original shipping carton and interior parts
only if they are all in good serviceable condition. If a
shipping carton or any of the interior part(s) are need-
ed, please call or write Customer Service Department
of McIntosh Laboratory. Refer to page 3. Please refer
to the Part List below for the correct part numbers.
Quantity Part Number Description
1 034420 Outer shipping carton only
1 034424 Turntable Platter/Accesories
Inner carton only
2 034425 Top and bottom foam pad
1 034426 Center foam pad
1 034427 Accessory box
1 034421 Turntable Inner carton only
1 034422 Turntable Top foam pad
1 034419 Bottom locating pad
2 034423 End caps
Turntable Platter
Turntable
without
Platter
Accessory box
Inner carton containing
Turntable Platter/Accessories
Inner carton containing
Turntable without
Platter
Outer shipping carton
containing platter/
accessories inner
carton and turntable
inner carton
Turntable Inner Carton
with foot locating pad
(pad is inside the carton
on the bottom)
Turntable Platter/Accessories
Inner Carton
To p
foam
pad
Center
foam
pad
Bottom
foam pad
Turntable Top foam pad