McIntosh MT5 User Manual

17
MT5
Phono Cartridge Loading
For optimum performance it is important the
PhonoCartridge be connected to the correct load
impedance. Refer to the respective Owner’s Manual
for the Preamplifier, Integrated Amplifier or Audio/
Video Control Center used with the MT5 for
additional information.
The Amethyst Low Output Moving Magnet
Cartridge supplied with the MT5 Turntable is a
Moving Magnet Type. Set the load resistance to 47 K
ohms and 50 pF Capacitance.
Tone Arm Lift
The McIntosh MT5 Precision Turntable has a Tone
Arm Lift Mechanism for safe placement and removal
of the cartridge stylus on the phonograph record.
Perform the following steps:
1. Push on the top part of the Tone Arm Lift Lever
towards the rear of the turntable. Refer to figure
52.
Power Selection
Rotate the POWER Switch to select the Turntable
Operation Mode desired. Refer to
figure 50.
Power Off - The Front Panel and
Turntable Platter
illumination are
switched OFF and
there is no Turntable
Platter rotation.
Standby - The Front Panel and
Turntable Platter will illuminate when
the McIntosh Preamplifier or A/V
Control Center is turned On.
Note: There must be a power control
connection between the MT5 and the
McIntosh Preamplifier or A/V Control
Center, in order for the Standby Mode
to function.
On - The Front Panel and Turntable Platter
illumination are Switched ON. The
Turntable Platter will rotate at the
selected speed.
Speed Selection
Rotate the SPEED Switch to select the playback
speed (33-1/3 rpm, 45 rpm or 78
rpm) of the phonograph record to
be played. Refer to figure 51.
2. Release the Tone Arm from the Tone Arm Holder.
Refer to figure 53.
3. Position the Tone Arm over the desired spot of the
Phonograph record.
4. Pull on the top part of the Tone Arm Lift Lever
towards the front of the turntable to begin
playback.
How to Operate the Turntable
Figure 53
Tone Arm Holder
Figure 51
Figure 50
Figure 52
Tone Arm Lift Lever

McIntosh MT5 Specifications

General

Brand	McIntosh
Model	MT5
Category	Turntable
Language	English