To Next PageTo Next Page
Need help?Do you have a question about the McQuay RoofPak RDS 800C and is the answer not in the manual?
General| Model | RDS 800C |
|---|---|
| Category | Air Handlers |
| Compressor Type | Scroll |
| Refrigerant | R-410A |
| Control System | MicroTech III |
| Cooling Capacity | 800, 000 BTU/h |
| Power Supply | 460V/3/60 |
Information on potential hazards and cautions for equipment operation.
Lists and describes unit control devices, settings, and functions.
Procedures and requirements for mechanical installation.
Specifies required clearances for unit installation and operation.
Details required clearances for accessing unit components for service.
Recommendations for minimum ventilation clearances.
Restrictions regarding overhead obstructions above the unit.
Instructions for assembling and installing the roof curb.
Method for mounting the unit using posts and rails.
Guidelines for safely rigging and handling the unit.
Procedures for refrigerant piping and charging DX coils.
Guidelines and recommendations for refrigerant piping.
Procedure for testing the refrigerant system for leaks.
Steps for properly evacuating the refrigerant system.
Detailed procedure for charging the unit's refrigerant system.
Information on refrigerant charge per circuit.
Details on connecting the condensate drain properly.
Procedures for piping steam, hot water, and chilled water coils.
Precautions for steam coils in freezing temperatures.
Details on the operation and adjustment of economizer dampers.
Description of the intake hood damper option for RAH units.
Description of the intake hood damper option for 0-30% airflow.
Information on face and bypass damper arrangements.
Procedures for installing ductwork connections.
Steps for installing duct static pressure sensor taps.
Steps for installing building static pressure sensor taps.
Procedures and requirements for field power wiring.
Procedures and requirements for field control wiring.
Description of the unit's power-up sequence.
Description of economizer operation modes.
Description of heating operation sequences.
Preliminary checks before starting the unit.
Steps to power up the unit.
Steps for starting the unit's fans.
Steps for starting the economizer.
Steps for starting heating systems.
Procedure for air balancing the unit.
Safety procedures for servicing control panel components.
Routine maintenance schedule and tasks.
