www.marketdirect.com.au Ph: 1300 494 494
50
Switching On Gas Operation
Never operate the heater without water in it!
If the wall cowl is positioned close to an opening window (or hatch) – in particular directly under it – the window must
remain closed when the water heater is in use (see warning plate).
Removing The Cowl Cover
• Grab the handle of the cowl cover.
• Press the palm against the lid (Fig.3a - 1) while pulling the lid off the cowl (Fig.3a - 2).
Select Water Heater Mode
Use the control panel to select the water heater mode
a = Red indicator lamp “Fault”
b = Water heater “On” 60 °C or 70 °C
c = Water heater “Off”
If there is air in the gas supply line, it may take up to a minute
before the gas is available for combustion. If the appliance
switches to “Fault” during this time, switch off the appliance
– wait 10 minutes – and switch on again!
When using the vehicle switches
Refer to operating instructions of the vehicle manufacturer or see switch labels.
Switching Off Gas Operation
– Switch off the water heater to position (Fig. 3b - c).
If the water heater is not to be used for a longer period, mount cowl cover
(non-observance of this point can lead to the function of the appliance being impaired
through water, dirt or insects), close stop cock valve in the gas supply line and close
the gas cylinder.
Before setting off on any journey, t cowl cap with the Truma UltraRapid
switched off. Please ensure that it is secure and has locked into place (risk of
accident). Defective cowl caps must not be used. Drain the water heater if
there is a risk of frost! Warranty claims will not be accepted if this is ignored.
To Next Page
Loading...
