Pump not working (no noise)
No power from control panel
Replace pump, Contact dealer for
replacement
Bad electrical connection
Check connections with multimeter
or test light
Pump working but no water flow
Turn on tap and hold finger over
nozzle for 5 seconds and release.
Repeat several times. If this fails, fill
water tank and use mains pressure
to pressurize tank
Check hoses ensuring none are
fouled
Damaged / worn pump diaphragm
Turn on valve on gas bottle
Gas hose on cooker not connected
Check bayonet is securely
connected into receiver
Check regulator is not blocked with
dirt, wasps nests etc
Check hose is not twisted and
kinked
• Remember that first use after connecting gas will take a little while for the gas to purge the line to the
cooktop. Hold the control knob down for up to 4 minutes
To Next Page
Loading...
