60 MONTHS / 50,000KM SERVICE
Inspect for damage and lubricate. Check bolt Torque to 76Nm
Inspect for condition and operation
Check brake function and webbing
Lubricate and check bushes for excess movement. Torque bolts to 190Nm
Inspect and adjust. Check lining thickness and drum wear
Replace bearings, seals and lubricate. Check stub axle condition and wear.
Replace split pin.
Inspect condition and torque to 125Nm (12mm studs)
(140Nm 14mm studs alloy rims) (200Nm 14mm studs steel rims)
Inspect for abnormal wear, damage and correct pressure
Check all lights are functioning
Check terminals and voltage at full charge
Check condition and correct latch/lock adjustment for correct 30-50% compression
Check all structural fixing are secure.
66 MONTHS / 55,000KM SERVICE
Inspect for damage and lubricate. Check bolt Torque to 76Nm
Check cable and adjust if necessary
Check brake function and webbing
Lubricate and check bushes for excess movement. Torque bolts to 190Nm
Inspect and adjust. Check lining thickness and drum wear
Remove, clean and re-lubricate. Inspect for wear and replace if necessary
Inspect condition and torque to 125Nm (12mm studs)
(140Nm 14mm studs alloy rims) (200Nm 14mm studs steel rims)
Inspect for abnormal wear, damage and correct pressure
Leak, test, check stove operation and hose/coupling condition
Check terminals and voltage at full charge
Check condition and correct latch/lock adjustment for correct 30-50% compression
Check all structural fixing are secure.
To Next Page
Loading...
