Page 20 69 Series - Operator’s Manual
February 2019Section 6 - Function Tests
Note:Verify that there are no fault codes shown on ground control display.
Test the Oscillate System (elevated position)
Press the lift function select button. The indicator light should turn on. Raise the platform
approximately 10 feet (3 m) from the ground.
Press the drive function select button. The indicator light should turn on.
Drive the left steer tire into a 4 in (10 cm) deep hole.
Result: All four tires should maintain firm contact with the ground.
Drive the right steer tire into a 4 in (10 cm) deep hole.
Result: All four tires should maintain firm contact with the ground.
Note:Verify that there are no fault codes shown on ground control display.
1.
2.
3.
•
3.
•
To Next Page
Loading...
Need help?
General
