EasyManuals Logo

Mec 69 Series User Manual

Default Icon
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
Page 22 69 Series - Operator’s Manual
February 2019Section 7 - Operating Instructions
In cold conditions, 20°F (-6°C) and below, warm the engine for 5 minutes before operating to prevent
hydraulic system damage.
In extreme cold conditions, 0°F (-18°C) and below, machines should be equipped with optional cold
start kits. Attempting to start the engine when temperatures are below 0°F (-18°C) may require the
use of a booster battery.
Operation from Ground
Turn the key switch to ground control.
Turn the ground red Emergency Stop button clockwise to the on position
Pull out the platform red Emergency Stop button to the on position.
Start the engine.
To Position Platform
Press the lift function enable button.
Press the platform up/down button to activate the up function or the down function.
Drive and steer functions are not available from the ground controls.
Engine Idle Select
Select the engine idle (rpm) by pressing the button and with the engine and rabbit icon to extinguish
the indicator light.
Operation from Platform
Turn the key switch to platform control.
Turn the ground red Emergency Stop button clockwise to the on position
Pull out the platform red Emergency Stop button to the on position.
Start the engine.
To Position Platform
Press the lift function select button. The indicator light should turn on.
Press and hold the function enable switch on the control handle.
Activate the proportional control handle in the desired direction.
To Steer
Press the drive function select button. The indicator light should turn on.
Press and hold the function enable switch on the control handle.
Turn the steer wheels with the thumb rocker switch located on the top of the control handle.
To Drive
Press the drive function select button. The indicator light should turn on.
Press and hold the function enable switch on the control handle.
Increase speed: Slowly move the control handle off center.
Decrease speed: Slowly move the control handle toward center.
Stop: Return the control handle to center or release the function enable switch.
1.
2.
3.
4.
1.
2.
1.
2.
3.
4.
1.
2.
3.
1.
2.

Other manuals for Mec 69 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mec 69 Series and is the answer not in the manual?

Mec 69 Series Specifications

General IconGeneral
BrandMec
Model69 Series
CategoryScissor Lifts
LanguageEnglish

Related product manuals