Page 28 Micro 13-XD - Operator’s Manual
July 2020Section 10 - Maintenance
Use only recommended lubricants. Improper lubricants or incompatible
lubricants may cause as much damage as no lubrication.
Watch for makeshift “fixes” which can jeopardize safety as well as lead
to more costly repair.
Inspection and maintenance should be performed by qualified personnel
familiar with the equipment.
Routine Maintenance
NEVER perform work or inspection on the machine with the platform
elevated without first blocking the scissor assembly with the
Maintenance Lock.
See page 24 for instructions.
Important: The operator may perform only maintenance items on the Pre-Start Inspection Checklist.
Frequent and Annual maintenance must be performed by qualified service technicians.
Pre-Start Inspection
Perform routine maintenance as identified in the Pre-Start Inspection Checklist on page 30.
Frequent and Annual Maintenance
Frequent Inspection Checklists and Annual Inspection Reports must be completed by qualified
service technicians trained and authorized to perform maintenance on this machine, and must be
done in accordance with the procedures outlined in the service manual. Scheduled maintenance
inspection checklists are included in this manual for use by qualified service technicians.
Machines that have been out of service for more than three months must have the Frequent
Inspection Checklists completed before returning to service.
To Next Page
Loading...
