Page 31 Micro 13-XD - Operator’s Manual
July 2020Section 10 - Maintenance
Frequent Inspection Checklist
This checklist must be used at 3-month intervals or every 150 hours of
machine use, whichever occurs first. Failure to do so could result in
death or serious injury.
Frequent Maintenance Inspections should be conducted by qualified service technicians only.
Photocopy this page for reuse. Keep inspections records up to date. Record and report all
discrepancies to your supervisor. See the Service & Parts Manual for specific instructions.
Model Number Serial Number Hour Meter Reading
Initial Description
Perform all checks listed on Pre-Start Inspection.
Inspect the condition of hydraulic fluid in the reservoir. Oil should be a clear and amber in
color.
Batteries
Electrical Wiring
Tires and Wheels
Emergency Stop
Key Switch
Horn (If Equipped)
Drive Brakes
Drive Speed - Stowed
Drive Speed - Raised
Drive Speed - Slow
Hydraulic Oil Analysis
Tank Venting System
Additional maintenance requirements for severe conditions
If the machine is used in very dusty, exceptionally hot or exceptionally cold conditions, replace
the Hydraulic Cap Breather Filter (under normal conditions replace every 6 months or 300 hours,
whichever comes first).
Date Inspected By
To Next Page
Loading...
