Page 14 Micro19 - Service & Parts Manual
October 2021
General Machine Maintenance
Instructions in this portion of the manual are to be used in conjunction with the Pre-Start, Frequent
and Annual Inspection checklists found in this machine’s Operator’s Manual.
IMPORTANT:Scheduled maintenance inspection checklists are included in the Operator’s
Manual for use only by qualified service technicians. Only qualified service
technicians may perform repairs to the machine. After repairs are completed,
the operator must perform a Pre-Start Inspection before proceeding to the
Functions Test.
HYDRAULIC FLUID UNDER PRESSURE CAN PENETRATE AND BURN
SKIN, DAMAGE EYES, AND MAY CAUSE SERIOUS INJURY, BLINDNESS,
AND DEATH. REPAIR LEAKS IMMEDIATELY. FLUID LEAKS UNDER
PRESSURE MAY NOT ALWAYS BE VISIBLE. CHECK FOR PIN HOLE
LEAKS WITH A PIECE OF CARDBOARD, NOT YOUR HAND.
NEVER PERFORM WORK OR INSPECTION ON THE MACHINE WITH
THE PLATFORM ELEVATED WITHOUT FIRST BLOCKING THE SCISSOR
ASSEMBLY WITH THE MAINTENANCE LOCK (SEE THE INTRODUCTION
PORTION OF THIS MANUAL).
PERFORM SCHEDULED MAINTENANCE AT RECOMMENDED INTERVALS.
FAILURE TO PERFORM SCHEDULED MAINTENANCE AT RECOMMENDED
INTERVALS MAY RESULT IN A DEFECTIVE OR MALFUNCTIONING
MACHINE AND MAY RESULT IN INJURY OR DEATH OF THE OPERATOR.
KEEP MAINTENANCE RECORDS CURRENT AND ACCURATE.
IMMEDIATELY REPORT ANY DAMAGE, DEFECT, UNAUTHORIZED
MODIFICATION OR MALFUNCTION TO YOUR SUPERVISOR. ANY DEFECT
MUST BE REPAIRED PRIOR TO CONTINUED USE. DO NOT USE A
DAMAGED, MODIFIED OR MALFUNCTIONING MACHINE.
Never leave hydraulic components or hoses open. Plug all hoses and
fitting immediately after disassembly to protect the system from outside
contamination (including rain).
Never open a hydraulic system when there are contaminants in the air.
Always clean the surrounding area before opening hydraulic systems.
Use only recommended lubricants. Improper lubricants or incompatible
lubricants may cause as much damage as no lubrication.
Watch for makeshift “fixes” which can jeopardize safety as well as lead to
more costly repair.
Inspection and maintenance should be performed by qualified personnel
familiar with the equipment.
General Machine Maintenance
Section 10 - Maintenance
To Next Page
Loading...
