Mec Micro19 - Page 23

Page 20 Micro19 - Operator’s Manual
August 2021Section 7 - Operating Instructions and Function Tests
Operation from Ground
Drive and steer functions are not available from the ground controls.
Turn the Key Switch to ground control.
Set the red Emergency Stop buttons to the ON position at both the ground
and platform controls.
Be sure the battery pack is connected before operating the machine.
1.
2.
3.
ART_4987
Check the area above and around the machine for obstructions and
electrical power lines before operating the machine.
To Position Platform
Move the up/down toggle switch according to the markings on the control panel.
ART_4988
Operation from Platform
Turn the Key Switch to platform control.
Set the red Emergency Stop buttons to the ON position at both the ground
and platform controls.
Be sure the battery pack is connected before operating the machine.
1.
2.
3.
ART_4989
Check the area above and around the machine for obstructions and
electrical power lines before operating the machine.
To Position Platform
Press the lift function select button.
Press and hold the Function Enable Switch on the control handle.
Move the control handle according to the markings on the control panel.
1.
2.
3.
Control Handle
Function
Enable
ART_5020