Page 36 Micro19 - Operator’s Manual
August 2021
Troubleshooting
Should you experience erratic operation or notice any malfunction while
operating this machine, discontinue use immediately.
Call for assistance and report the incident to your supervisor, and do
not use the machine until it has been checked by a trained, qualified
mechanic.
Machine functions will not operate
Master disconnect turned on?
Batteries properly connected?
Batteries fully charged?
Key Switch in proper position?
Both Emergency Stop Switches reset?
Function Enable Switch not activated?
Hydraulic fluid level low?
Obvious fluid leak or damaged component?
Wires disconnected, broken, or loose?
Diagnostic panel on?
Platform Control Box Fault Code present? Refer to service manual or contact MEC Technical
Support.
•
•
•
•
•
•
•
•
•
•
•
Section 11 - Troubleshooting
Troubleshooting
To Next Page
Loading...
