Mec MME20 - Workplace Inspection

Page 18 Mast Series - Operator’s Manual
April 2021Section 6 - Pre-Operation & Workplace Inspection
Workplace Inspection
Do Not Operate Unless:
You learn and practice the principles of safe machine operation contained in this operator’s manual.
Avoid hazardous situations.
Always perform a risk assessment of the planned work.
Inspect the workplace. Know and understand the workplace inspection before going on
to the next section.
Always perform function tests prior to use.
Only use the machine as it was intended.
Fundamentals
The risk assessment helps the operator determine if the workplace is suitable for safe machine
operation. It should be performed by the operator prior to moving the machine to the workplace.
It is the operator’s responsibility to read and remember the workplace hazards, then watch for and
avoid them while moving, setting up and operating the machine.
Workplace Inspection
Be aware of and avoid the following hazardous situations:
Drop-offs or holes
Bumps, floor obstructions or debris
Sloped surfaces
Unstable or slippery surfaces
Overhead obstructions and high voltage conductors
Hazardous locations
Inadequate surface support to withstand all load forces imposed by the machine
The presence of unauthorized personnel
Other possible unsafe conditions
1.
2.
3.
4.
5.
•
•
•
•
•
•
•
•
•