page 29
It is possible to activate a backlight on the Tornado display.
To access the BACKLIGHT function, press and hold the
MENU key until page 1 of the main-menu appears.
Press and release the MENU key twice to access the main
menu page 3. Using the UP and DOWN keys, move the
arrow cursor to BACKLIGHT, and press ENTER.
The display shows BACKLIGHT OFF and ON:
Use the UP and DOWN keys to move the arrow cursor
against the desired selection and press ENTER.
The display will return to the main menu page 3, press the
ESC key to return to the main display.
When activated, the backlight will remain on for
30 seconds since the last key press or last load applied
registering over 2% of full scale.
To conserve battery power, it is possible to activate an
auto-off function so that the Tornado powers down 5 or
10 minutes after either the last key press, or the last load
applied greater than 2% of full scale.
To access the AUTO OFF function, press and hold the
MENU key until page 1 of the main-menu appears.
Press and release the MENU key twice to access the main
menu page 3. Using the UP and DOWN keys, move the
arrow cursor to AUTO OFF, and press ENTER.
The display shows AUTO OFF:
OFF Disables auto-off function.
5 MINUTES Tornado will automatically power
down after 5 mins.
10 MINUTES Tornado will automatically power down
after 10 mins.
Use the UP and DOWN keys to move the arrow cursor
against the desired selection and press ENTER.
The display will return to the main menu page 3, press the
ESC key to return to the main display.
BACKLIGHT
BACKLIGHT sub-menu 1
Note: Battery consumption is
doubled when using the backlight.
AUTO OFF
AUTO OFF sub-menu 1
Note: The AUTO OFF function is
disabled whilst accessing the menu
pages, regardless of setting.
To Next Page
Loading...
