MEDCAPTAIN SYS-6010 - Replacing the Internal Battery

23
3.3 Replacing the Battery
 Remove an internal battery.
(1) Use a screwdriver to loosen the battery cover fixing screws at the bottom of the
pump.
(2) Remove the battery cover.
(3) Disconnect the battery cable connector.
(4) Remove the battery.
 Install the internal battery
(1) Insert the connector of the battery cable into the battery.
(2) Insert the new battery into the battery compartment.
(3) Attach the battery cover.
(4) Use a screwdriver to tighten the screws securing the battery cover.