14 | Installation
2. 2.1 Position pump on trolley.
Make sure that the front
of the pump and the
standard rail point
forward.
2.2 Connect pump with
4 screws.
2.3 Attach the cable holder
with the two screws to the
pump.
2. 2.1 Attach the Safety Set to
the pump.
Remove transport
lock
1. 1.1 Remove the red note
1.2 Remove 3 screws and
store them for later use.
5.2
Set up mobile version
(if available)
1. 1.1 Position top part of trolley
on bottom part, making
sure the tubing fits as
shown.
1.2 Connect parts with
4 screws.
5.3
Assembly of the
optional clampholder
(when using the
trolley)
1. 1.1 Press and hold the blue
release knob.
1.2 Attach the clampholder to
the standard rail by
releasing the blue knob.
5.4
Set up the Safety Set 1. 1.1 Attach the mechanical
overflow protection to
the lid. Pull gently down-
wards to make sure it is
open / deactivated.
1.2 Attach the lid to the jar.
1.3 Close the two lid clamps.
1.1
1.2
1.3
5.5
To Next Page
Loading...
Need help?
General
