EN
Replacing defective fuse | 25
3. Replace the defective fuse(s). Make sure that the technical
specifications are correct.
T 1.6 AH, 250 VAC, 5 x 20 mm
12 Replacing defective fuse
WARNINGS
Before replacing the fuse, pull the mains plug from Basic out of the fixed mains socket.
4. 4.1 Close (push back) the fuse
holder.
1. 1.1 Disconnect the Basic from
the mains.
1.2 If attached, remove the
cable holder (2 screws on
bottom).
2. 2.1 Open (pull out) the fuse
holder on the back of the
Basic.
5. 5.1 Reconnect the Basic to
the mains again.
5.2 Switch on the Basic again.
To Next Page
Loading...
Need help?
General
