EN
Operating instructions | 19
CAUTIONS
When the Basic is used for wound drainage, the negative pressure should be set
according to instruction of the specialist and not cause any wound damage.
Changing vacuum
level
1. 1.1 Clamp patient tubing
1.2 Turn vacuum regulator to
select the correct vacuum
according to the particular
application.
1.3 Check vacuum gauge for
setting.
Placing out of
operation after use
1. 1.1 Touch on/off button to
switch off the Basic.
2. 2.1 Disconnect the mains
plug from the fixed mains
socket.
3. Clean and disinfect the Basic. See chapter 14.
7.3
7.4
To Next Page
Loading...
