To Next Page

To Previous Page

4 Getting started

English

4.4 "Step-on"-functionWeight only /

If the location of the scales is changed, a new calibration is necessary (see 4.2).

Make sure, the scales are placed on a firm and level surface.

Step onto the scales and stand still. The device switches on automatically.

After the rings lit up, your weight is displayed in the display of the scales.

Step down from the scales. The scales switch off automatically after 5 seconds.

4.5 Programming personal data

The scales can store data for up to 4 persons: Target weight, height, age, gender and

fitness grade. These data are stored in 4 user memories, which are represented by

a specific user symbol (avatar) . The scales have preset values. These are:

male, 30 years old, 175 cm, non-athletic. G

Press the ON-button .

The identification (iD) for the user symbol selection mode (avatar-

mode) appears in the display . Use the + - and - - buttons to

select a user symbol.

choose to input a target weight, the scales will calculate the difference

to your measured weight for any future measurement and will show

this difference in the display and additionally with the flashing circles.

Your selection will be shown for 2 seconds.

Use the + - and - - buttons to input your selected target weight and

confirm the selection with the OK-button .

Please choose one of the 4 different symbols (avatars).

Confirm the selection with the OK - button .

Choose, if you want to input a target weight value or not. If you want to

If you have selected to input a target weight, you will now be asked

to input this target weight. You may input a weight, which you want to

reach. You can control your weight development and your success

by using this feature.

Medisana TargetScale User Manual

Questions and Answers: