* Representative endoscope for illustrative purposes only. For exact
port locations, refer to endoscope manufacturer’s instruction guide.
Air/Water Blanking Cap
Align the connector with the
air/water bottle port and push
to fully engage.
If you have any questions regarding SCOPE BUDDY 24 Hour Disposable Tubing connections, in the U.S., please contact
MEDIVATORS Technical Support at 1-800-444-4729. Outside the U.S., please contact your MEDIVATORS Distributor.
READ ALL INSTRUCTIONS PRIOR TO CONNECTION
Locate the endoscope port* and follow the instructions for attaching the
corresponding Endoscope Connector. All connectors must be attached.
Pinch Clamp
(For use with endoscopes without
a Forward Water Jet Channel)
Pinch sides together until they
‘click’ to clamp.
Biopsy Channel Blanking Cap
Align rubber tting with biopsy inlet
and push over inlet until fully engaged.
ADDITIONAL REQUIRED ENDOSCOPE CONNECTIONS (Sold separately)
SCOPE BUDDY™ DISPOSABLE TUBING CONNECTORS (Figure 1)
Air Probe Tubing
Align tubing with air probe and
push tubing onto probe until
fully engaged.
Channel Plug
Align the channel plug with the piston ports
andpush to compress spring before sliding the
frame forward to fully engage.
Suction Tubing
Align silicone tubing with suction
barb and push tubing onto barb
until fully engaged.
B5
B1
B4
A
1
SCOPE BUDDY Disposable Tubing Delivery
Tube (see Connection Instructions on page 2)
4 Forward Water Jet Connector
2 Air Probe Tubing 5 Pinch Clamp
3 Suction Tubing A
Fluid Intake Line
(see Connection Instructions on page 2)
CHANNEL PLUG
P/N CLM-220-HU1004
B5
B1
B4
B2
B3
B2, B3 not needed
Forward Water Jet
Connector
(For endoscopes with a Forward
Water Jet Channel) Align with
forward water jet port, insert
and screw clockwise until fully
engaged. Important: Attach the FWJ
connector rst, prior to any other
connectors.
SB-110-HU1001 24 HOUR DISPOSABLE TUBING CONNECTION GUIDE FOR OLYMPUS
®
ENDOSCOPES
Using MEDIVATORS™ SCOPE BUDDY
®
Flushing Aid
To Next Page
Need help?
General
