Meec tools 000841 - USE; Fuel Information and Filling; Starting the Clearing Saw

EN
55
USE
Fuel
WARNING!
• Risk of personal injury.
• Petrol is highly ammable and can in
some circumstances be explosive.
• Switch o the engine and allow it to cool
before relling with fuel.
• Follow all the safety instructions for
handling fuel.
• Always ll up with fuel before use.
NOTE:
• The recommended mixing ratio is 40:1
– 40 parts of petrol to 1 part of oil.
• Mix petrol with 2-stroke oil of good
quality, intended for air-cooled 2-stroke
engines.
Filling
1. Shake the container with the fuel mix.
2. Place the clearing saw on a level, stable
surface with the fuel tank cap up.
3. Clean the tank cap and the area around the
opening to avoid impurities getting into the
tank.
4. Open the tank cap carefully to release any
overpressure. Use a funnel and do not
overll.
5. Carefully ll up with fuel. Avoid spilling.
6. Replace the fuel cap and rmly tighten.
7. Wipe o any spilled fuel and allow the
residue to evaporate before starting the
engine.
NOTE:
• Never use oil intended for 4-stroke
engines or for water-cooled 2-stroke
engines. This oil can contaminate the
spark plug and exhaust port, or cause
the engine to seize.
• Fuel mixed with oil that has stood for
more than one month can contaminate
the carburettor and prevent the engine
from working properly. Store surplus
fuel in a dark and cool place in an
airtight container.
• Switch o the engine before lling up
with fuel. Never ll up with fuel when
the engine is running or hot. Fire risk.
Starting the clearing saw
1. Put the power switch on the throttle
control handle in the ON position, press the
throttle control B, throttle control A and the
safety catch so that the throttle control A
locks in half-pressed position.
2. Move the choke lever to OFF position.
FIG. 12
3. Press at least 10 times on the primer bulb
when rst starting the machine.
FIG. 13
4. To start the engine, pull the starter cord
slowly until it catches (10–15 cm) and then
pull quickly a few times to pull round the
engine and distribute the oil.
5. Move the choke lever to ON position.
6. Pull the starter cord until the engine starts.
7. Press in throttle control A and B. When the
engine is idling use throttle control A to
control the speed.
8. When using the trimmer head the feed
mechanism must be tapped against the
ground rst to feed out the line.
9. Stop the rotation of the trimmer head by
releasing throttle control A and B.
10. Switch o the engine by pressing the power
switch.