Meec tools 760-008 - Description; Adjusting the Handle; Engine

ENGLISH
41
DESCRIPTION
1. Guard
2. Starter cord
3. Throttle control lever
4. Safety handle
5. Trimmer control lever
6. Primer
OPERATION
Adjusting the handle
1. Hold the handle (1) with one hand and
loosen both adjustment knobs (2). Do not
unscrew them completely.
2. Press out the handle sides and turn the
handle to the required position.
3. Stand behind the handle and check it is at
the required height.
4. Tighten the adjustment screws to 18-20
Nm.
5. Insert the starter cord (3) in the holder (4)
on the right side of the handle.
Engine
NOTE! The engine is supplied without oil. Fill with oil before starting the engine.
Fill with oil
1. Place the trimmer on a flat surface.
2. Unscrew the oil cap/dipstick.
3. Use a funnel to avoid oil spills when filling.
4. Do not overfill. Follow the instructions below to check the oil level.