Mega H-400GA - Page 27

ALARM CODE ALARM MESSAGE SOLUTION
24 BLADE DOWN BUTTON
OUT-OF-ORDER
1. Fix the breakdown
2.Press the saw frame raise button
25 FEED FORWARD BUTTON
OUT-OF-ORDER
1. Fix the breakdown
2.Press the saw frame raise button
26 FEED BACKWARD BUTTON
OUT-OF-ORDER
1. Fix the breakdown
2.Press the saw frame raise button
27 FRONT VISE CLAMP CONFIRM
BUTTON OUT-OF-ORDER
1. Fix the breakdown
2.Press the saw frame raise button
28
29
30
31 PIECE COUNTER NUMBER REACHED
1. Press the saw frame raise button
2.Press the CLEAR button on control
panel
32 SAW FRAME RAISE BUTTON
OUT-OF-ORDER
1. Fix the breakdown
2.Press the saw frame approach button
33 CUT LENGTH NOT SET
1.Reset the length
34 CUT QUANTITY NOT SET
1.reset the quantity
35 BLADE SAW START TO FRONT VISE
NO CLAMP
1. Fix the breakdown
2.Press the saw frame raise button
36 WHEEL COVER NO CLOSE
1. Fix the breakdown
2.Press the saw frame raise button
24