Mega H-400GA - Error Codes and Solutions

6.3 Error Code
ALARM CODE ALARM MESSAGE SOLUTION
1
2 RAME RAISE TIME OVER
1. Fix the breakdown
2.Press the saw frame raise button
3 FRAME RAISE POSITION L/S
OUT-OF-ORDER
1. Fix the breakdown
2.Press the saw frame raise button
4
5 FEED FORWARD SOLENOID
OUT-OF-ORDER
1. Fix the breakdown
2.Press the saw frame raise button
6 OUT-OF-MATERIAL
1. Fix the breakdown
2.Press the saw frame raise button
7 SAW FRAME QUICK DOWN AGAINST
LOWER LIMIT
1. Fix the breakdown
2.Press the saw frame raise button
8 IDLE WHEEL SENSOR
OUT-OF-ORDER
1. Fix the breakdown
2.Press the saw frame raise button
9
10 ENCODER OUT-OF-ORDER OR
SCREW JAM
1. Notify the agent
11 UPPER LIMIT SWITCH ERROR
1. Fix the breakdown
2.Press the saw frame raise button
12 FRONT LIMIT SWITCH
OUT-OF-ORDER
1. Fix the breakdown
2.Press the saw frame raise button
13 BACKWARD SOLENDID
OUT-OF-ORDER
1. Fix the breakdown
2.Press the saw frame raise button
14
1. Fix the breakdown
2.Press the saw frame raise button
15 INVERTER TRIPPED
1. Fix the breakdown
2.Press the saw frame raise button
16
17
18 HYDRAULIC MOTOR OVER LOAD
1. Fix the breakdown
2.Press the saw frame raise button
19
20 SAW BLADE HEIGHT TOO LOW FOR
VISE OPENING
1. Fix the breakdown
2.Press the saw frame raise button
21
22 COOLANT PUMP MOTOR OVER
LOAD
1. Fix the breakdown
2.Press the saw frame raise button
23 BLADE START BUTTON
OUT-OF-ORDER
1. Fix the breakdown
2.Press the saw frame raise button
23