Need help?Do you have a question about the MEGAFLO Eco and is the answer not in the manual?
Details the necessary mains water pressure and flow rate.
Steps involved in commissioning the installed system.
Explains the function and installation of the 3 bar pressure reducing valve.
Specifications for discharge pipe D1 and the tundish.
Specifies requirements for discharge pipe D2.
Details the thermal cut-out and motorised valve for indirect units.
Details heater operation, thermostat adjustment, and control unit access.
Outlines routine maintenance tasks and frequency.
Identifies common faults, causes, and remedies.
Safety warnings, immersion heater use, flow behavior, and fault diagnosis.
General| Model | MEGAFLO Eco |
|---|---|
| Category | Boiler |
| Material | Stainless Steel |
| Energy Efficiency Rating | B |
| Thermostat | Adjustable Thermostat |
| Maximum Operating Pressure | 10 bar |
| Maximum Operating Temperature | 85°C |
| Type | Unvented Cylinder |
| Insulation | Polyurethane Foam |
| Warranty | 2 years on components |
| Capacity | Varies by model (e.g., 125L, 150L, 170L, 200L, 210L, 250L, 300L) |
To Next Page