54
Chapter 6. Telnet (Remote Monitoring)
Section1. Introduction
NetAgent supports multiple Network Management systems and LAN protocols.
After finishing hardware installation, you are now able to choose any utilities
that provided by NetAgent to monitor and control UPS.
Here are introduction for using Telnet.
Section2. Telnet Configuration
n Select “Start” from Windows, click “Run” to key-in NetAgent IP Address
Fig.46 Telnet startup
o Successful link-up display:
Fig.47 Telnet Connection
pInitial to setup, please press “Enter” to enter telnet main screen. If the User
Name and Password had been set before, please enter actual value to
access.
Fig.48 Telnet: Input User Name / Password
q Main screen is as follows:
To Next Page
Loading...
Need help?
General
