∼
19
given by a printer, and therefore waits at the end of
each line. This time (“Printer delay time”) and the
printer report language can be changed.
1. Press and hold the key then turn the
rotary selector switch from the
OFF position to
the RCL position. The code Pdt is displayed.
2. Release the key.
To change the Printer speed
1. Toggle the key to scroll through and
display the code
Pdt
2. Press the key. The current setting is
displayed.
3. Toggle the and keys until the
required setting is displayed.
4. To save the new setting, press the key.
The bleeper sounds and
std is displayed. To
abort the new setting, press the EXIT button.
To select the printer language
1. Press the key to scroll through and display
the code lng.
2. Press the key. The current printer report
language is displayed as 1 (English) or 2 (as
given on the type label on the User Guide cover).
Note: Language 2 can be changed – see below.
3. Press the key until the required language
setting is displayed
4. To save the new setting, press the key.
The bleeper sounds and is
Std displayed. To
abort the new setting, press the EXIT button.
Changing the Second Printer Language
Language 2 can be changed using Download Manager
Program supplied with your instrument. Full instructions
are contained in the User Guide with the CD.
Data-logging
Enabling/disabling data-logging:
The factory setting is that logging is disabled and
storage is enabled.
1. Turn the range knob to ‘
RCL’ while holding
down the key. Pdt will be displayed.
2. Press the key until log is showing
3. Press the key to show the current status
of the logging function, i.e on or off.
4. Pressing the key toggles the setting
between on and off.
5. Press the key to accept the setup, or the
EXIT button to quit.
To Next Page
Loading...
