Repair and Warranty
27
The instrument circuit contains static sensitive devices,
and care must be taken in handling the printed circuit
board. If the protection of an instrument has been
impaired it should not be used, and be sent for repair by
suitably trained and qualified personnel. The protection is
likely to be impaired if, for example, the instrument shows
visible damage, fails to perform the intended
measurements, has been subjected to prolonged storage
under unfavourable conditions, or has been exposed to
severe transport stresses.
New Instruments are Guaranteed for 3 Years from the
Date of Purchase by the User.
Note:
Any unauthorized prior repair or adjustment will
automatically invalidate the Warranty.
Instrument Repair and Spare Parts
For service requirements for Megger Instruments
contact:-
Megger Limited or Megger
Archcliffe Road Valley Forge Corporate Center
Dover 2621 Van Buren Avenue
Kent, CT17 9EN. Norristown, PA 19403
England. U.S.A.
Tel: +44 (0) 1304 502243 Tel: +1 (610) 676-8579
Fax: +44 (0) 1304 207342 Fax: +1 (610) 676-8625
or an approved repair company.
Approved Repair Companies
A number of independent instrument repair companies
have been authorised for repair work on most Megger
instruments, using genuine Megger spare parts. Consult
the Appointed Distributor/Agent regarding spare parts,
repair facilities, and advice on the best course of action to
take.
Returning an Instrument for Repair
If returning an instrument to the manufacturer for repair, it
should be sent freight pre-paid to the appropriate address.
A copy of the invoice and of the packing note should be
sent simultaneously by airmail to expedite clearance
through Customs. A repair estimate showing freight return
and other charges will be submitted to the sender, if
required, before work on the instrument commences.
To Previous Page
Loading...
