To Next PageTo Next Page
Need help?Do you have a question about the Megger DELTA4000 and is the answer not in the manual?
General| Power Supply | 100-240 VAC, 50/60 Hz |
|---|---|
| Operating Temperature | -10 °C to +50 °C |
| Measurement Parameters | Tan Delta, Capacitance |
| Accuracy (Capacitance) | ± (0.5% + 1 pF) |
| Display | LCD |
| Communication Interface | USB, Ethernet |
Check received equipment against packing list and report shortages or damage to the carrier.
Overview of the DELTA4000 system for testing high-voltage electrical insulating systems up to 12 kV.
Essential safety measures for operating high-voltage equipment to prevent electric shock hazards.
Definitions and importance of warning and caution notices used throughout the manual.
Detailed electrical and physical specifications of the DELTA4000 test set.
Description of supported test modes like Ungrounded Specimen Testing (UST) and Grounded Specimen Testing (GST).
Table detailing maximum measurable specimen capacitance at various voltages and loading times.
Key safety features integrated into the DELTA4000 for user and equipment protection.
Lists of included and optional accessories for the DELTA4000 test set.
Identification and function of controls and connectors on the DELTA4000 control unit side panel.
Description of connector panel on the HV unit, including HV OUTPUT and GROUND connections.
Features of the optional industrial 12-inch controller for the DELTA4310A.
Critical safety warnings before setting up and operating the high-voltage test set.
General guide and diagrams for setting up the test set for various transformer tests.
Explanation of the Delta Control software interface for test mode selection and operation.
Illustrates typical test setups for two-winding and three-winding transformer tests.
Details on how to use the voltage control interface for setting and adjusting test voltages.
Configuration options within the Delta Control software for test parameters and preferences.
Overview of PowerDB Lite for asset-based testing and data management with DELTA4000.
Step-by-step guide for installing the PowerDB Lite software on a computer.
Guidance on entering transformer nameplate data for test setup and correction.
Detailed procedures for performing overall insulation tests on transformers.
Steps for measuring the C1 insulation of transformer bushings.
Procedures for measuring the C2 insulation of transformer bushings.
Methods for measuring excitation current to identify transformer core and coil defects.
Guidelines for performing routine maintenance and cleaning of the DELTA4000.
Information on calibration procedures and recommended intervals for accuracy checks.
General guidelines and procedures for basic troubleshooting of the DELTA4000.
Procedure to check overall functionality and stray signal losses of the DELTA4000 and cable.
Information on the repair service offered by Megger for equipment malfunction.
