17
REPAIR AND WARRANTY
The instrument circuit contains static sensitive devices, and care must be taken in handling the printed circuit board. If the protection of
an instrument has been impaired it should not be used, and be sent for repair by suitably trained and qualified personnel. The protection
is likely to be impaired if, for example, the instrument shows visible damage, fails to perform the intended measurements, has been
subjected to prolonged storage under unfavourable conditions, or has been exposed to severe transport stresses.
Note: Any unauthorised prior repair or adjustment will automatically invalidate the Warranty.
Instrument Repair and Spare Parts
For service requirements for Megger Instruments contact:
Megger Limited
Archcliffe Road
Dover
Kent
CT17 9EN
England
Tel: +44 (0) 1304 502100
Fax: +44 (0) 1304 207342
Megger
Valley Forge Corporate Center
2621 Van Buren Avenue
Norristown PA
19403
USA
Tel: +1 (610) 676-8500
Fax: +1 (610) 676-8610
Megger
4271 Bronze Way
Dallas TX
75237-1017
USA
Tel: +1 (800) 723-2861 (U.S.A. only)
Tel: +1 (214) 330-3203 (International)
Fax: +1 (214) 337-3038
or an approved repair company.
Approved Repair Companies
A number of independent instrument repair companies have been approved for repair work on most Megger instruments, using genuine
Megger spare parts. Consult the Appointed Distributor / Agent regarding spare parts, repair facilities and advice on the best course of
action to take.
To Next Page
Loading...
Need help?
General
