Returning an Instrument for Repair
If returning an instrument to the manufacturer for repair, it should be
sent freight pre-paid to the appropriate address. A copy of the invoice and
of the packing note should be sent simultaneously by airmail to expedite
clearance through Customs. A repair estimate showing freight return and
other charges will be submitted to the sender, if required, before work on
the instrument commences.
End of life disposal
WEEE
The crossed out wheeled bin placed on the Megger products is a reminder
not to dispose of the product at the end of it’s product life with general
waste.
Megger is registered in the UK as a Producer of Electrical and Electronic
Equipment.
The Registration No is WEE/HE0146QT
Batteries
The crossed out wheeled bin placed on the batteries is a reminder not to
dispose of them with general waste at the end of their life.
This product contains a lithium backup cell built into a DIL-32 IC package.
Battery replacement should only be performed by a Megger authorised
repair agent, who will correctly dispose of the spent battery.
For the purpose of end of life disposal only, the battery is located on the
micro pcb, and is marked DS1556W-120
These batteries are classified as Industrial Batteries. For disposal in the UK
contact Megger Limited.
For disposal of batteries in other parts of the EU contact your local
distributor. Megger is registered in the UK as a producer of batteries.
The registration number is BPRN00142
REPAIR AND WARRANTY
13
The instrument contains static sensitive devices, and care must be taken in
handling the printed circuit board. If an instrument’s protection has been
impaired it should not be used, but sent for repair by suitably trained and
qualified personnel.
The protection is likely to be impaired if for example; it shows visible
damage; fails to perform the intended measurements; has been subjected
to prolonged storage under unfavourable conditions, or has been
subjected to severe transport stresses.
NEW INSTRUMENTS ARE GUARANTEED FOR 1 YEAR FROM THE
DATE OF PURCHASE BY THE USER.
NOTE: Any unauthorized prior repair or adjustment will automatically
invalidate the Warranty.
INSTRUMENT REPAIR AND SPARE PARTS
For service requirements for Megger Instruments contact:
Megger Limited or Megger
Archcliffe Road Valley Forge Corporate Centre
Dover 2621 Van Buren Avenue
Kent CT17 9EN Norristown PA 19403
England. U.S.A.
Tel: +44 (0) 1304 502 243 Tel: +1 610 676 8579
Fax: +44 (0) 1304 207 342 Fax: +1 610 676 8625
or an approved repair company.
Approved Repair Companies
A number of independent instrument repair companies have been
authorised for repair work on most Megger instruments, using genuine
Megger spare parts. Consult the Appointed Distributor/Agent regarding
spare parts, repair facilities, and advice on the best course of action to
take.
To Next Page
