www.megger.com t
23
Operating Principle
5.19 Setting the transmitter codes
1. Make sure that the transmitter is switched off before setting the codes.
2. Press and hold down the Level button, then press the power button. The current transmitter signal
code is displayed, then press Power key to turn on the meter.
3. To select a different transmitter code, press the Level button to cycle through the available transmitter
codes (1 - 7).
4. Once the required code is displayed, turn the transmitter off. The selected code will be remembered
and used when next turned on.
5.20 Transmitter Flashlight
The flashlight located on the transmitter can be turned on and off by pressing the flashlight button. The
flashlight turns off automatically after approximately 60 seconds to conserve battery life.
To Next Page
Loading...
General