Need help?Do you have a question about the Megger MCT105 and is the answer not in the manual?
Describes the MCT105 kit's purpose, components, and how the signal is traced.
Lists the key capabilities and functions of the MCT105 Cable Tracer and Fault Locator.
Provides information on checking the Megger website for updates and new resources.
Defines standard symbols and terms used for safety instructions in the user guide.
Outlines general safety precautions and conditions for using the instrument.
Explains overvoltage categories (CAT IV, CAT III, CAT II) relevant to safe operation.
Identifies and labels the physical components and terminals of the transmitter.
Details the indicators and information shown on the transmitter's LCD screen.
Explains the function of fuses and how to check for fuse failure.
Identifies and labels the physical components and buttons of the receiver.
Details the indicators and information shown on the receiver's LCD display.
Explains how to operate the device in the primary cable tracing mode.
Describes methods for tracing cables and conductors within complete circuits.
Details finding cable interruptions or tracing cables in open circuits.
Describes detecting short-circuits or tracing conductors in complete circuits.
Explains tracing cables and components within house installation circuits.
Details finding interruptions in plastic-sheathed cables.
Describes using two transmitters for more accurate interruption detection.
Explains detecting errors or faults in electrical under-floor heating systems.
Details finding obstructions or bottlenecks within installation pipes.
Explains how to precisely locate fuses within a distribution board.
Describes methods for locating short-circuits in conductors.
Explains the process for tracing installed water and heating pipes.
Details how to detect the direction of installed water and heating pipes.
Explains how to trace all circuits within an entire house wiring system.
Describes techniques for achieving greater location depth when tracing lines.
Explains the method for tracing conductors that are buried within the soil.
Provides tips on how connecting to live conductors can enhance detection range.
Explains how to identify multiple installed conductors using multiple transmitters.
Describes using the receiver for non-contact voltage detection.
Instructions for setting and configuring transmitter signal codes.
Information on operating the built-in flashlight feature on the transmitter.
Step-by-step instructions for replacing the batteries in the transmitter and receiver.
Provides guidance on how to clean the instrument case.
Information regarding the disposal of electrical and electronic equipment according to WEEE.
Guidelines for the responsible disposal of batteries.
To Next Page
General