4 VIDAR ZP-BR01E BR0150GE
1 SAFETY
1
Safety
1.1 Symbols on the
instrument
Caution, refer to accompanying docu-
ments.
Protective conductor terminal.
WEEE, Waste Electrical and Electronic
Equipment. Please utilize your local
WEEE collection facilities in the dispo-
sition of this product and otherwise
observe all applicable requirements.
1.2 Safety instructions
Important
Read and comply with the following in-
structions.
Always comply with local safety regula-
tions.
Warning
People with pacemakers must not use the VIDAR
since a pacemaker can be disturbed by the electrical
discharges.
When testing a circuit breaker that is permanently
mounted you must make certain that there is no risk
of burning out the collector busbar if it can not be
disconnected.
Circuit breakers on vehicles and also circuit break-
ers of the plug-in type must be tested outside their
holders.
Applying abnormally high voltage across a pair of
contacts in vacuum may be dangerous. However, as
a precautionary measure against possibility of ap-
plication of higher than recommended voltage (or a
contact spacing below normal), it is recommended
that all operating personnel stands at least 3 m
(10 ft) away in front of the breaker.
High voltage/current on input/output terminals.
Do not attempt to service the instrument yourself.
Opening or removing covers may expose you to dan-
gerous voltage. If you attempt to service the instru-
ment yourself the warranty is no longer valid.
Do not use any accessories that are not intended for
use together with the instrument.
Disconnect the instrument from the mains before
cleaning. Use a damp cloth for cleaning. Do not use
liquid cleaners or aerosol cleaners.
Important
To Next Page
Loading...
