MEHEN M10 - Page 19

- 19 -
Developer
Target
temperature
-15 ~ 2
°C
-8
Target temperature.
Temperature1
-15 ~ 80
°C
2.0
Minimum temperature of S1 (refer to Fig 1)
Temperature2
-15 ~ 80
°C
-1.0
Minimum temperature of S2 (refer to Fig 1)
Temperature3
-15 ~ 80
°C
-5.0
Minimum temperature of S3 (refer to Fig 1)
Motor speed 1
 Low speed
 Intermittent low
 High speed
 Intermittent high
Low speed
Agitation speed in temperature range S1
(refer to Fig 1)
Compressor 1
 Continuous
 Intermittent
Continuous
Compressor mode in temperature range S1
(refer to Fig 1)
Motor speed 2
 Low speed
 Intermittent low
 High speed
 Intermittent high
High
speed
Agitation speed in temperature range S2
(refer to Fig 1)
Compressor 2
 Continuous
 Intermittent
Continuous
Compressor mode in temperature range S2
(refer to Fig 1)
Motor speed 3
 Low speed
 Intermittent low
 High speed
 Intermittent high
Low speed
Agitation speed in temperature range S3
(refer to Fig 1)
Compressor 3
 Continuous
 Intermittent
Continuous
Compressor mode in temperature range S3
(refer to Fig 1)
Motor speed 4
 Low speed
 Intermittent low
 High speed

Intermittent high
Low speed
Agitation speed in temperature range S4
(refer to Fig 1)
Compressor 4
 Continuous
 Intermittent
Continuous
Compressor mode in temperature range S4
(refer to Fig 1)
5.7 Language
This controller offers a quick language setting.
 On Home-page, press Parameter and enter Hardness-setting;
 Then press Language to enter Language-setting;
 Press the Language you want.