WARNING
This is a safety design. Never open the cylinder door when the machine is running,
otherwise may cause serious damage to body or machine.
5.12 Compressor Overtime
The parameter “Compressor-max.-working-time” is a safety device.
If the compressor continuous running time exceeds this limit, the controller will
stop the compressor and gives a warning.
The operator can:
Press Take out to take out the product.
The possible reasons for this warning can be:
Inappropriate recipe and material used.
Inappropriate parameters.
Pool cooling condition and/or pool cooling ability.
TIPS
The agitator will continuous. It’s necessary to check and solve the problem(s)
before run it again.
5.13 Initialization the Controller
This initialization will reset all the user and system parameters to factory setting.
This operation need to input the user security code 1111.
CAUTIOIN
The parameters are important to ensure the correct performance of the machine.
The initialization can be operated by a qualified technician only.
5.14 Error Alarm
The machine will stop running and show message when an error detected.
Press Reset to exit.
Improve cooling condition.
To Next Page
Loading...