MEHEN M10 - Page 23

- 23 -
Motor overload
Product temperature is too low.
Product hardness is too high.
Set the parameters properly.
Too much product quantity.
Reduce the product quantity.
Pressure overload
Pool cooling condition.
Improve cooling condition.
Too much gas quantity.
Release gas properly.
Refrigerate pipe is block.
Check and fix the block.
Current sensor error
Temperature sensor error
The sensor cable is loose.
Connect it tightly.
Sensor probe fault.
Replace the probe.
Sensor module fault.
Replace the sensor module.
PLC fault.
Replace the PLC.
TIPS
It will display the detected error(s) only.
Even sensor error happened, the machine still can be used with other programs.
CAUTIOIN
Find out and fix the problem(s) before run the machine again.
5.15 Operation With Error
In case of electric current sensor error, the machine still can be used with
Time-mode or Temperature-mode.
In case of both electric current sensor and temperature sensor have problems, the
machine still can be used with Time-mode.
Tip
A small signal “x” on the screen indicates certain error(s) happened.
Tip
Even you can use the machine with Time-mode, we still suggest you to contact
with service timely to fix the problems.
5.16 A Typical Producing Operation
 Well latch the cylinder door and output door then put in proper quantity
material.
 Press the program name to start producing.
 After the setting target achieved, it will stop freezing and continue the agitating,
also the buzz will alarm to remind the operator,