Now the operator can open the output door to take out the product,
You may use low-speed if you want to take it slowly, otherwise you can use
high-speed to get a faster taking out,
Please switch to high speed at the end of the process for better cleaning up
inside,
Press STOP after taking out.
TIPS
The agitation will continue and the freezing will stop after the product is ready.
Under Temperature mode, the compressor will restart if the product temperature
increase more than 2 degrees, the compressor will stop when the temperature
achieve again. This will repeat until the operator take out the product and stop it
manually.
Please press Take Out directly to take out the product if the operator thinks the
product is ready during the process. Please don’t stop the machine entirely then
take out, this will result in more components abrasion.
To Next Page
Loading...